CAMERAPREPA General MxAnalytics Settings

Open Help with keyword "videomotionanalysis"

MOBOTIX c25 CAMERAPREPA General MxAnalytics Settings

Configuration générale	Value	Description
Arming		Arm MxAnalytics: Controls image analysis: Enabled: activate image analysis. Désactivé(e): deactivate image analysis. SI: Image analysis armed by signal input. CS: Image analysis armed by custom signal as defined in Configuration générale des événements.
		Programme hebdomadaire: Time table profile for time-controlled image analysis. (Programmes hebdomadaires)
		Low-Light Suppression: Disables analysis if illumination drops below selected value.
MxAnalytics storage is not activated. Please activate storage and reboot in order to use MxAnalytics export functionality. Make sure that the device is formatted accordingly. If not, you should format it here first.
Detection Settings	Value	Description
Detection Area		Detection Area Definitions: Format: lens, window lens: 0=right, 1=left. window: can be defined as a rectangle as well as a polygon. For a detailed description of window definitions and additional variables, please refer to the help page. Note: If no detection area is provided, the camera determines the area autonomously. Note: All user-defined coordinates are relative to the entire sensor area. The origin (0,0) corresponds to the lower left corner, (1279,959) to the upper right corner (if the image is mirrored or rotated, the coordinate system changes accordingly). *Detection areas can also be defined by Shift-click+click in the live image and pressing Add detection area.*
	Show Detection Area
Mounting Height		Mounting Height: Mounting height of the camera [150..1000 cm].
Tilt Angle		Tilt angle of the camera.: Configure the tilt angle of the camera in degrees. Installation on/in the ceiling corresponds to -90°, installation on/in the wall corresponds to 0°.
Object Display Settings	Value	Description
Bounding Box		Bounding Box Color: Enable visualization of bounding boxes by selecting a color.
Object Track		Object Track Color: Enable visualization of object tracks by selecting a color.
Object Halo		Object Halo Color: Enable visualization of object halos by selecting a color.
		Transparency: Set the transparency of the object halos [0..100%].
Counting Corridor Settings	Value	Description
Counting Corridors	0,start=800x440,end=800x520,width=360,id=1,name=Corridor 1	Configure counting corridors: Format: lens,start=point,end=point,width=width lens: 0=right, 1=left. start: starting point of corridor (direction). end: ending point of corridor (direction). point: x coordinate x y coordinate. width: width of the corridor. For a detailed description of corridor definitions and additional variables, please refer to the help page.
Alarm and Counting Corridors		Alarm and Counting Corridor Style: Appearance of alarm and counting corridor.
	Show Counting Corridor IDs	Counting Corridor IDs: The corridor IDs will be shown at the bottom of each corridor.
	Show Counter Values	Counter Values: Counter values will be shown next to the center of each corridor.
Heatmap Settings	Value	Description
Reference Image		Save Reference Image: Click to save the current image as reference image for heatmap reports.
		Show Reference Image: Click to show the current reference image.
		Delete Reference Image: Click to delete the current reference image.
Live Image Display	Show Heatmap	Show Heatmap in Image: Shows the heatmap since the last reset of MxAnalytics in the live image and in the recordings.
	Show Legend	Legend: Displays the legend of the heatmap.